A unique Master PIN Code must be entered prior to any further programming of the lock. Definitions All Code Lockout Mode: This feature is enabled by the Master PIN code. When enabled, it restricts all user PIN code access (except the Master PIN code). When the unit is in Lockout…
Installing the Yale Real Living Touchscreen Deadbolt YRD 220/240
Unpack the Lock The lock is packed representative of how it will install on the door. Before installing the lock on the door: A. Inside escutcheon 1. Loosen the screw (Phillips #2) holding the battery cover(The screw remains attached to battery cover). 2. Slide the battery cover up…
Defaulting the Hitron HT-DW1 Door/Window Sensor
Remove the battery from the sensor. While holding down the tamper switch, reinsert the battery. Release the tamper switch when the LED turns green.
Defaulting the Visonic MCT-302 Analog Sensor
Remove the cover by loosening the screw on the top of the sensor. Remove the existing battery. Press and hold down the sensor’s tamper switch(There may be a spring over the tamper switch. It is not necessary to remove the spring). Insert the battery into the sensor and wait for…
Defaulting the Visonic MCT-340 Door/Window Sensor
The MCT-340 Door/Window sensors are used for monitoring entry and exit areas of your home, as well as perimeter areas, the same way the full size contacts are. The door/window sensor can be placed on any door or window. Be sure to place the smaller magnet on the part of…
Defaulting the Jasco In Wall Dimmer(45857)
From the Hub From your controller or hub interface, choose to remove or delete the lighting device as instructed. The device will be removed from the ZigBee network following indication from your controller. All configuration parameters will be reset after the device is removed from the network. 1. Lift the air-gap…
Installing the Jasco In Wall Dimmer(45857)
WARNING: CONSULT A PROFESSIONAL ELECTRICIAN PRIOR TO WORKING WITH ELECTRICAL WIRING. Changing the Color of the Paddle Lift the Air Gap tab at the base of the paddle. Push side tabs in on one side and then the other to release paddle. Lift the cover up and off. Simply put the…
Defaulting the Jasco In Wall Relay(45856)
From the Hub From your controller or hub interface, choose to remove or delete the lighting device as instructed. The device will be removed from the ZigBee network following indication from your controller. All configuration parameters will be reset after the device is removed from the network. Manually To manually reset and remove the device…
Installing the Jasco In-Wall Relay (45856)
WARNING: CONSULT A PROFESSIONAL ELECTRICIAN PRIOR TO WORKING WITH ELECTRICAL WIRING. Changing the Color of the Paddle Lift the Air Gap tab at the base of the paddle. Push side tabs in on one side and then the other to release paddle. Lift the cover up and off. Simply put the…
Installing the LG Zigbee Smart Bulb(EM35x)
Installation Disconnect power before installing a LED Bulb. • Install LED Bulb to light fixture. LED Bulb can be installed to lighting fixture and E26 Base Socket. • If you have and want to connect to home controller, please refer to the controller’s user guide for instructions on how to pair this…