The MCT-340 Door/Window sensors are used for monitoring entry and exit areas of your home, as well as perimeter areas, the same way the full size contacts are. The door/window sensor can be placed on any door or window. Be sure to place the smaller magnet on the part of…
Defaulting the Jasco In Wall Dimmer(45857)
From the Hub From your controller or hub interface, choose to remove or delete the lighting device as instructed. The device will be removed from the ZigBee network following indication from your controller. All configuration parameters will be reset after the device is removed from the network. 1. Lift the air-gap…
Installing the Jasco In Wall Dimmer(45857)
WARNING: CONSULT A PROFESSIONAL ELECTRICIAN PRIOR TO WORKING WITH ELECTRICAL WIRING. Changing the Color of the Paddle Lift the Air Gap tab at the base of the paddle. Push side tabs in on one side and then the other to release paddle. Lift the cover up and off. Simply put the…
Defaulting the Jasco In Wall Relay(45856)
From the Hub From your controller or hub interface, choose to remove or delete the lighting device as instructed. The device will be removed from the ZigBee network following indication from your controller. All configuration parameters will be reset after the device is removed from the network. Manually To manually reset and remove the device…
Installing the Jasco In-Wall Relay (45856)
WARNING: CONSULT A PROFESSIONAL ELECTRICIAN PRIOR TO WORKING WITH ELECTRICAL WIRING. Changing the Color of the Paddle Lift the Air Gap tab at the base of the paddle. Push side tabs in on one side and then the other to release paddle. Lift the cover up and off. Simply put the…
Installing the LG Zigbee Smart Bulb(EM35x)
Installation Disconnect power before installing a LED Bulb. • Install LED Bulb to light fixture. LED Bulb can be installed to lighting fixture and E26 Base Socket. • If you have and want to connect to home controller, please refer to the controller’s user guide for instructions on how to pair this…
Defaulting the LG Zigbee Smart Bulb(EM35x)
To reset the device to factory resets, turn power off and then on 7 times in rapid succession. The bulb will indicate it has been factory reset by blinking 5 times.
Defaulting the Sercomm Smart Plug(EM358x) (SZ-ESW01)
Remove the Smart Plug from it’s power source. Press and hold the Join/Leave button while plugging the Smart Plug back into the power source. The LED is blinking to indicate an attempt to join the Touchstone network.
Installing the Sercomm Smart Plug(EM358x) (SZ-ESW01)
Installation Put the SZ-ESW01 into wall receptacle. Make sure the receptacle is working properly. If it is controlled by a wall switch, which must be set to ON all the times. Attach the appliance to the SZ-ESW01. Operation Auto Operation: If a power interruption should occur while the device is…
Defaulting the Centralite 3 Series Nightlight Repeater
Remove the Nightlight Repeater from the power source. Hold down the primary button. While holding down the button, plug the Nightlight Repeater back into it’s power source. The Nightlight Repeater should begin to flash Blue, indicating it is attempting to join the Touchstone network. A short green flash indicates successful…