Getting Started Connecting the Battery Using a Phillips head screwdriver, unscrew and remove the battery door. Connect battery to the connector inside the battery compartment and reinstall battery door. Installing to Outlet Find an open wall outlet and remove the center screw that secures the face plate. Plug the device…
Defaulting the SMC Motion Sensor(SMCMT10-Z)
Remove the top cover from the SMCMT10-Z. Remove the battery. Press and hold the enrollment switch in the RF circuit inside the SMCMT10-Z until you replace the battery. Replace the battery while still pressing the enrollment switch then release the switch. The RF LED flashes three times to signal the…
Installing the SMC Motion Sensor(SMC10MT-Z)
Finding a Suitable Location The technology used in the SMCMT10-Z resists false alarm hazards. However, avoid potential causes of instability such as: Direct sunlight on the SMCMT10-Z. Heat sources within the SMCMT10-Z field of view. Strong drafts onto the SMCMT10-Z. Large animals (greater than 100lbs) within the SMCMT10-Z field of…
Installing the Visonic CLIP Motion
CLIP Applications General Guidance for Installation Installation Procedures Regular Mounting Bracket Mounting Setting the Coverage and Range A 4-pin jumper is used to select 3 ranges, according to the type of installation, for the curtain beams. The purpose of the range setting is to ensure optimal signal processing…
Installing the Visonic Pet-immune Motion Detector (NEXT-K985-SMA)
General Guidance for Installation 1. Do not install near sources of heater/cooling. 2. Do not aim at windows. 3. Do not install outdoors. 4. Do not install where direct sunlight can strike the unit. 5. Do not install near high-voltage electrical lines. 6. Do not install behind any obstruction.…
Installing the Hitron HT-DW1
It is highly recommended to attach the transmitter to the fixed frame and the magnet to the movable part (door or window). Make sure that the magnet is located not more than 6 mm (0.25 in.) from the transmitter’s marked side. Hitron’s HT-DW1 is a micro door/ window sensor, using a magnetic…
Installing the Visonic MCT-302
Auxiliary Input Wiring Remember! If your application does not require the auxiliary input, be sure to set DIP switch SW2 to OFF and to short the input terminals together with a piece of jumper wire. Connect the auxiliary detector’s alarm contacts across the MCT-302 auxiliary input terminals. If the auxiliary input of the…
Installing the Tyco MCT-340
Mounting It is highly recommended to attach the transmitter to the top of the door/window on the fixed frame and the magnet to the movable part (door or window). Make sure that the magnet is located not more than 6 mm (0.25 in.) from the transmitter’s marked side. The transmitter…
Installing the Door Window Sensor Rev 2 (SMCDW02-Z)
Inserting the Battery Find the locking mechanism on the bottom of the SMCDW01-Z. Holding the SMCDW01-Z in one hand, carefully insert the tip of a screwdriver into the locking mechanism. Push lightly upwards from the back of the SMCDW01-Z until the back plate separates from the sensor. Find the supplied…
Installing the SMC Water Sensor (SMCWA10-Z)
Find a suitable location for the wireless radio. Note: For best signal strength, place the wireless radio as high as possible. Find a suitable location to place the water sensor probe. Examples include baseboards, drip pans, etc. Placement should be as close to the surface as needed. The sensor is…