Hold down the tamper switch on the bottom of the device. Insert the battery into the sensor. Wait for the RF module’s green LED to light. In order to see the green LED on the circuit board, the cover must be separated from the housing (to expose the circuit board)…
Visonic Pet-immune Motion Detector (NEXT-K85-SMA)
The Visonic Next+ K9-85 SMA is a PowerCode wireless digital PIR detector designed to enable homeowners to secure their homes while allowing their pets to move freely anywhere in the house. Employing Visonic’s patented “”Target Specific Imaging™”” optical system (TSI) and unique pet identification software algorithm, the Next+ K9-85 SMA…
Deleting/Modifying a Sensor
When you delete a sensor, Touchstone disables any rules that reference the sensor. To delete a sensor, click SETTINGS on the toolbar to display the settings page. Click the type of sensor that you would like to delete to display the sensor’s settings page. Click the icon next to the…
Adding a Sensor
Sensors can be added to your system during activation, or at a later time. If you want to add a sensor that was not included with the original Touchstone package, make sure your service provider supports it. Note: If you are attempting to pair a sensor that has been previously deleted…
Defaulting the Visonic Pet-immune Motion Detector (NEXT-K85-SMA)
Open the cover by loosening the small screw at the bottom of the sensor and expose the circuit board and remove the circuit board. Locate the battery on the back side of the board and remove it. With the battery removed, press and hold the tamper spring. Reinsert the battery…
Defaulting the Visonic Water Sensor (MCT-550 SMA)
To default the Water Sensor, remove the cover by loosening the screw found at the top of the unit. Remove the battery and depress the tamper spring. Reinsert the battery, immediately release the tamper spring, and press and release the tamper spring again. The LED on the sensor will begin…