You can add lights when you activate Touchstone or at a later time. If you want to add a light that was not included with the original Touchstone package, make sure your service provider supports it. To add lights, click Settings on the tool bar to display the settings menu. Click…
Adding a Thermostat
You can add a thermostat when you activate Touchstone, or at a later time. If you want to add a thermostat that was not included with the original Touchstone package, make sure your service provider supports it. To add a thermostat, click on SETTINGS in the toolbar. Click Thermostats to display…
Adding a Camera
You can add cameras when you activate Touchstone, or at a later time. If you want to add a camera that was not included with the original Touchstone package, make sure your service provider supports it. To add a camera, click SETTINGS on the toolbar. Click Cameras to display the camera…
Adding a Sensor
Sensors can be added to your system during activation, or at a later time. If you want to add a sensor that was not included with the original Touchstone package, make sure your service provider supports it. Note: If you are attempting to pair a sensor that has been previously deleted…
Defaulting the CLIP Motion Detector
To default the CLIP Motion Sensor, remove the cover by loosening the screw at the bottom of the unit to expose the circuit board and battery. Remove the battery and press and hold the tamper spring. With the tamper spring held down, insert the battery, immediately release the tamper spring,…
Defaulting the Visonic Pet-immune Motion Detector (NEXT-K85-SMA)
Open the cover by loosening the small screw at the bottom of the sensor and expose the circuit board and remove the circuit board. Locate the battery on the back side of the board and remove it. With the battery removed, press and hold the tamper spring. Reinsert the battery…
Defaulting the Visonic Water Sensor (MCT-550 SMA)
To default the Water Sensor, remove the cover by loosening the screw found at the top of the unit. Remove the battery and depress the tamper spring. Reinsert the battery, immediately release the tamper spring, and press and release the tamper spring again. The LED on the sensor will begin…
Defaulting the Visonic MINI Door/Window Sensor (MCT-320-SMA)
To default the slimline door/window sensor: 1) Remove the cover using a small flathead screwdriver. 2) Remove the battery; press and hold down the tamper switch(small black button near battery). 3) With the tamper switch still held down, insert the battery and release the tamper switch. 4) The LED…
Defaulting the SMC Door Window Sensor Rev 2 (SMCDW02-Z)
Door/Window sensors are used for monitoring entry and exit areas of your home, as well as perimeter areas. The door/window sensor can be placed on any door or window. Be sure to place the smaller magnet on the part of the surface that will have the most amount of motion(i.e.…