To default the thermostat, place the thermostat into programming mode by pressing between the hold button and the fan button. While continuing to hold between the hold button and the fan button, swipe down on the right slider until “01″ is displayed. When the “01” is displayed, it indicates you are in “programming mode.”…
PEARL THERMOSTAT PROGRAMMING
Before you enter programming mode to program the thermostat, the device needs to be in an “off” state. To turn the thermostat off, press the “Mode” button until “Off” appears on the screen. To enter programming mode: PRESS BETWEEN the hold button and the fan button. Continue to hold and swipe down on the…
TESTING THE THERMOSTAT(PEARL)
Testing Thermostat Operation After completing any necessary configuration make sure the thermostat is in Cool mode by pressing the MODE button until Cool is displayed at the bottom of the screen. Make sure the system is not calling for Cooling by setting the setpoint several degrees above the room temperature.…
THERMOSTAT INSTALLATION(PEARL)
Before you begin installing your thermostat, please be advised that It is always a good practice to consult the owner’s manual for your HVAC system. If necessary, consult an HVAC technician to ensure proper installation. Locating the Thermostat If this is to replace an existing thermostat, just use the existing…
VERIFYING THE THERMOSTAT(PEARL) IS READY TO PAIR
Joining Your Thermostat to the Hub The thermostat needs to be joined to the Hub after installation. The first step in the join process is to make sure the Hub is in it’s join network mode. To do this, navigate to the Add Devices tab in the subscriber portal and…