The 3-Series Lamp Module introduces new functionality to existing in-home lighting systems. By placing the Lamp Module between an outlet and any lamp in your home, you can instantly add advanced automation features. The Lamp Module can also set dimming levels for any dimmable light bulb. Not only can the…
IMPORTANT – When installing the Door/Window Sensor, remember to align the narrow end of the arrows pointing at each other. 1) The transmitter (large part of the sensor) should be mounted on the fixed surface (e.g. door frame) and the magnet (small part of the sensor) on the moving surface (e.g.…
Compact Wireless Weather Proof IP Camera. iCamera is Day and Night Network Camera with VGA resolution and 802.11n WiFi connectivity. There are two deployment scenarios for the iCamera product. The design accommodates both environments for outdoor IP54 and indoor application. It supports H.264 Baseline, MPEG-4 and Motion-JPEG triple codec and…
True Day / Night Vision Waterproof IP Camera the OC810 is an IP65 rated (Water/Dust Proof) IP camera for outdoor video surveillance applications. With high quality progressive CMOS sensor, this camera is capable of providing H.264, MPEG-4 and M-JPEG triple streaming at VGA resolution up to 30fps. This is an…
This article applies to the following models: Centralite 3 Series Lamp Module Centralite 3 Series Appliance Module Centralite Azela Lamp Module Centralite Azela Appliance Module Verify that the wall outlet is powered. If the wall outlet is powered by a wall switch, then the wall switch MUST be kept ON…
To default the thermostat, place the thermostat into programming mode by pressing between the hold button and the fan button. While continuing to hold between the hold button and the fan button, swipe down on the right slider until “01″ is displayed. When the “01” is displayed, it indicates you are in “programming mode.”…
To enter programming mode: PRESS FAN and MODE buttons at the same time. Then press the UP ARROW button while the fan and mode button are still held. The clock display will change to indicate which programming mode you’re currently in. The display will start at 10:00. If there is ever…
Testing Thermostat Operation After completing any necessary configuration make sure the thermostat is in Cool mode by pressing the MODE button until Cool is displayed at the bottom of the screen. Make sure the system is not calling for Cooling by setting the setpoint several degrees above the room temperature.…
Before you begin installing your thermostat, please be advised that It is always a good practice to consult the owner’s manual for your HVAC system. If necessary, consult an HVAC technician to ensure proper installation. Locating the Thermostat If this is to replace an existing thermostat, just use the existing…